Automatic soldering machine safety test method:
1. The automatic soldering machine should be placed in a dry and ventilated place. If it is placed outdoors, in addition to the cover of the welding machine itself, the automatic soldering machine must be equipped with protection measures against rain and snow. The place where the welding machine is placed should be kept neat and clean. Combustion and explosives are stacked.
2. The secondary line of the automatic soldering machine must be connected and fastened without looseness. The number of joints on the secondary line should not exceed three. The cross-sectional area of the welding cable should be correctly selected according to the capacity of the welding machine to avoid insulation aging caused by long-term overload.
3, the welding tongs should comply with the relevant national regulations, can ensure that the welding rod can be clamped under any inclination, the insulation is good, the handle insulation layer is complete, and the welding tongs and the different lines should be connected reliably. The connection should be light and soft, easy to use, no overheating, the conductor is not exposed, and the screen of the clamp is good. It is strictly forbidden to use the metal structure, pipeline, track, etc. of the plant as the welding secondary circuit.
4. The insulation resistance between the winding and the outer casing of the welding transformer is not less than 1 megohm. It is required to test the insulation resistance of the welder at least once every six months, and the records are complete.
In short, the detection of the safety performance of the automatic soldering machine is very important, because the operator of the automatic soldering machine often touches the electricity, and the casualties caused by the poor condition of the electric welding facilities sometimes occur, especially the electric shock accidents. Therefore, in order to prevent accidents, the safety performance of the automatic soldering machine should be regularly checked.